Checking and changing a raw-water impeller

The raw-water impeller is a small rubber part that pumps seawater through your engine's cooling system. When it fails, the engine overheats, and if nobody notices quickly the exhaust and engine can be badly damaged. It is cheap, and checking it is one of the most useful habits a boat owner can have.

Key points

  • Most manufacturers recommend changing the impeller every season or after a set number of engine hours. Check your engine manual.
  • Look for cracked, torn or permanently bent vanes; replace if in doubt.
  • If vanes are missing, find the pieces: they usually block the heat exchanger or cooler inlet.
  • Lubricate a new impeller with soapy water or glycerine, not petroleum grease.
  • Never run the engine without cooling water, even for a few seconds.

Why it matters

A flexible impeller pumps seawater through the heat exchanger, and on many boats into the exhaust to cool it. If the impeller fails, the engine overheats and the hot exhaust can melt hoses and mufflers. The first sign is often an overheat alarm, or steam instead of water coming out of the exhaust.

How often to change it

Follow your engine manufacturer's interval. As a rule of thumb many owners change it every season, or sooner if the boat has run in sandy or muddy water or sat unused for a long time. Rubber ages even when the engine is not running, so an old impeller in a little-used boat is still a risk.

How to inspect it

  1. Close the raw-water seacock and make sure the engine cannot be started.
  2. Remove the pump cover (usually a few screws) and take out the impeller, using an impeller puller or two pliers carefully.
  3. Inspect the vanes. Look for cracks at the base, tears, hardening, or vanes that stay bent. All of these mean replace it.
  4. Check the pump housing and cover for wear grooves. A badly scored cover reduces flow.
  5. Fit the new impeller with the vanes bent in the direction of rotation, lubricated with soapy water or glycerine.
  6. Fit a new gasket or O-ring, refit the cover, open the seacock, then start the engine and check that water flows from the exhaust within a few seconds.

If pieces are missing

Broken vanes travel downstream and usually stop at the heat exchanger inlet or a cooler. Find them before you run the engine again, or you will overheat even with a new impeller.

Do not use petroleum grease on the impeller. It can swell and weaken the rubber. Use the lubricant supplied, glycerine or soapy water.

Spares to carry

Keep at least one spare impeller, a cover gasket or O-ring and the right puller on board, and note the part number in your boat's log. The day you need it is rarely a day when a chandlery is nearby.

Viber WhatsApp