Key points
- Most boats in the Adriatic are hauled out and antifouled once a year.
- Hard antifouling suits faster boats and those dried out regularly; eroding (self-polishing) antifouling suits boats that stay in the water.
- Replace sacrificial anodes when they are about half worn, at least once a year.
- Use the haul-out to check through-hulls, seacocks, shaft, cutless bearing, propeller and rudder.
- Book early: spring is the busiest time in every yard.
How often
For most boats kept afloat in the Adriatic, once a year is right. Boats used hard in summer, or kept in warm, sheltered water, may need a mid-season hull clean by a diver as well. A boat that is dry-stored or used very little can sometimes stretch to longer, but the hull should still be inspected every year.
Choosing antifouling
| Type | Suits | Notes |
|---|---|---|
| Eroding / self-polishing | Most leisure boats that stay in the water | Wears slowly and keeps releasing biocide; less build-up of old paint layers |
| Hard | Faster motorboats, boats dried out or scrubbed often | Tough surface that can be cleaned; builds up layers over years |
Do not mix incompatible paints. If you do not know what is on the hull, ask the yard to check, or use a primer or tie-coat.
Anodes
Sacrificial anodes corrode so your propeller, shaft, sail-drive or outdrive do not. Replace them when they are about half worn, and at least once a year. Use the material your engine or drive manufacturer specifies. If anodes are wasting unusually fast, there may be an electrical problem on the boat or in the marina, and it is worth having an electrician look.
What to check while the boat is out
- Through-hulls and seacocks: open and close each one, check for corrosion and weeping.
- Propeller: dings, bent blades, growth in the hub.
- Shaft and cutless bearing: play in the bearing, condition of the shaft seal.
- Sail-drive or outdrive: bellows or seals, gear oil colour (milky oil means water).
- Rudder: play in the bearings, cracks, signs of water in the blade.
- Hull: blisters, impact damage, cracks around keel joints.
- Speed and depth transducers: clean them, and do not paint them unless they are made for it.
Planning a haul-out in Montenegro
- Book early. Yards around Boka Bay are busiest in spring, before the season.
- Agree a written work list and price with the yard before the boat comes out.
- Allow time. Weather, paint drying times and parts can stretch a few days into a couple of weeks.
- Have someone check the work before relaunch, especially seacocks, anodes and anything that was taken apart.