Storm prep: getting your boat ready for bura and jugo

Boka Bay is well sheltered, but two winds still catch owners out. Bura comes down off the mountains in cold, violent gusts. Jugo blows from the south-east, warm and wet, building swell and pushing water into the bay. Both put heavy loads on a boat that is not set up for them.

Key points

  • Bura is a cold north-easterly that arrives in sudden, powerful gusts; jugo is a warm south-easterly that builds swell and rain over a day or two.
  • Double every mooring line and protect it against chafe.
  • Remove or lash down anything with windage: sails, biminis, cushions, loose covers.
  • Check fender height and add more fenders on the side that will be pushed onto the quay or a neighbour.
  • Always inspect the boat after the storm, even if it looks fine from the quay.

Know the two winds

BuraJugo
DirectionNorth-east, down off the mountainsSouth-east, in from the sea
CharacterCold, dry, sudden and violent gustsWarm, humid, steady build, rain and swell
WarningCan arrive with little noticeUsually builds over a day or more
Main riskSnatch loads on lines and cleats, flogging canvasSwell and surge in exposed berths, chafe, water ingress

Check a local forecast, such as the Montenegrin hydrometeorological service or a marine forecast app, whenever you are away for more than a few days.

Mooring lines

  1. Double up. Add a second line next to each main line, each one led to its own cleat or ring, so one failure does not free the boat.
  2. Use stretch. Nylon lines and line snubbers absorb gust loads. Rigid, tight lines transfer every jolt straight to the cleats.
  3. Fit chafe protection wherever a line passes through a fairlead or over an edge. A hose sleeve or chafe guard is enough. A line can chafe through in one night of jugo surge.
  4. Check the lazy line or mooring at the bow or stern. In Mediterranean mooring this line holds the boat off the quay, so it must be tight and in good condition.
  5. Leave enough slack for the water level. Jugo can raise the water level in the bay. Lines that are bar-tight at normal level can overload when the boat rises.

Fenders

Set fenders at the height where the hull actually meets the quay or the next boat, and add extra fenders on the side the wind will push you onto. If your neighbour is badly fendered, it is your gelcoat that suffers, so it is worth a word with the marina.

Reduce windage

  • Take headsails off the furler, or wrap and tie them so the wind cannot get in.
  • Remove or fold and lash biminis, sprayhoods and cockpit cushions.
  • Tie down dinghies, paddleboards and anything on deck.
  • Close hatches and portholes, and check that cockpit drains are clear for the rain that comes with jugo.

Power and bilge

Make sure the bilge pump works on automatic and the batteries are charged. Shore power can trip in heavy weather, so a boat relying on a charger should start the storm with full batteries.

After the storm

Go aboard, or have someone go aboard, as soon as it is safe. Check every line and cleat for chafe and movement, look at fenders and the topsides for rubbing, check the bilge for water, look for leaks around hatches and windows, and check canvas and covers for tears. Write down and photograph anything you find, which you may need for insurance.

Never board in the middle of a bura. Gusts can knock you off a pontoon or passerelle. Add lines before the wind arrives, and inspect after it has eased.
Viber WhatsApp